Author Topic: Oirginal as found block chain for your Hard or Cushion Tire Safety  (Read 1900 times)

mike cates

  • Full Member
  • ***
  • Posts: 164
    • View Profile
Just found these sections of original Block Chain in rusty shape but good to complete an unrestored original display bike or wall hanger. Could be loosened up by soaking in penetrating oil and using some elbow grease. One inch pitch, laminated blocks made up of 6 laminates each , blocks profile are flat tops with concave bottoms, .520" block width, side plates are symmetrical profile varying from the block profile. One section is 24" pin-to-pin, one section is 19 1/2" pin-to-pin and one short section is as shown in photos.
This type chain was used on Lozier, and other brand HTS and CTS bicycles.
$75.00 + $8.30 USPS Small Flat Rate Box Shipping to the lower 48 states.
I haven't seen this offered at Copake Antique Bicycle Auction 2020.
CLICK ON PHOTOS BELOW TO ENLARGE THEM.
Mike Cates, CA.
(760) 473-6201 Voice Calls/Your Message and No Texts Please
cates0321@hotmail.com
« Last Edit: March 14, 2020, 05:30:18 PM by mike cates »